|
GL710/GL750 Cable Locks
 WARNING!! PLEASE READ BEFORE BEGINNING.
KEEP ALL FIREARMS UNLOADED AND OUT OF THE REACH OF CHILDREN AND OTHER UNAUTHORIZED USERS. DO NOT ATTEMPT TO USE THIS LOCK ON A LOADED FIREARM! NOT FOLLOWING ALL INSTRUCTIONS AND WARNINGS MAY RESULT IN AN ACCIDENTAL DISCHARGE CAUSING SERIOUS BODILY INJURY OR DEATH! A LOADED FIREARM MUST ALWAYS BE REGARDED AS DANGEROUS! GIVEN TIME, TOOLS OR DETERMINATION NO DEVICE OFFERS COMPLETE PROTECTION AGAINST DISCHARGE, MISUSE OR UNAUTHORIZED USER ACCESS. RE-INSPECT THIS LOCK, THE OPERATION & THE FIT WITH EACH USE. KEEP ALL AMMUNITION STORED IN A SEPARATE AND SECURED LOCATION AWAY FROM YOUR FIREARM. FOLLOW ALL RECOMMENDED SAFETY PRECAUTIONS PROVIDED IN YOUR FIREARMS OWNER MANUAL. THIS LOCK WILL NOT FIT ALL FIREARMS PROPERLY OR SECURELY. PROPER INSTALLATION AND INSPECTION IS VERY IMPORTANT. MOST SAFES WILL OFFER YOU THE MOST SECURE & SAFE STORAGE AVAILABLE.
Replace the lock if the protective cable coating becomes frayed, loose, torn or if the lock does not fit properly, fails to operate or function properly. Weinraub Enterprises Inc., Pro-Lok, our retailers and distributors are not responsible for incidental or consequential damages. If you have questions, concerns or do not completely understand the proper use, operation or installation of this product, contact Pro-Lok or your retailer prior to use.
PREPARE THE FIREARM FOR INSTALLATION OF THE LOCK:
ALWAYS POINT THE FIREARM IN A SAFE DIRECTION.
1) Put safety in the "on safe" position as instructed in your firearms owner manual.
2) Completely unload the firearm as instructed in your firearms owner manual.
3) Visually check the chamber, feed & magazine tube, verify the gun is completely unloaded.
INSTALL THE LOCK ON THE FIREARM:
4) Turn the key clockwise (until the key stops) to the "unlocked" position.
5) To remove the cable from the lock, HOLD the key all the way in the "unlocked" position and pull the cable
end from the lock body.
6) Thread the cable end through the barrel of the gun as indicated in the appropriate firearm photo below.
DO NOT operate the action with the lock in place. Damage to the firearm can occur.
7) With the key HELD ALL THE WAY in the "unlocked" position with one hand, insert the loose cable end
all the way (until it stops) into the receiving hole of the lock.
8) With one hand holding the cable end ALL THE WAY into the lock body, turn the key counter-clockwise to
the "locked" position & remove the key.
9) Pull sharply on the cable end to verify the cable is locked.
TROUBLESHOOTING:
If the loose cable end does not enter the receiving hole:
Make sure you are holding the key ALL THE WAY in the unlocked position while you are inserting the cable into the lock.
If you cannot remove the key from the lock:
The key can only be inserted and removed in the completely "locked" position. If the cable end is inserted into the lock body and the key cannot be turned ALL THE WAY to the "locked" position and the key removed; the cable end is not fully inserted in the receiving hole of the lock body. To correct this problem:
A) Turn the key clockwise and HOLD the key ALL THE WAY in the "unlocked" position.
B) Push the cable end further into the lock body (all the way) and hold the cable end in this position while you
turn the key back to the "locked" position. Remove the key | 
